Tektronix Keithley 4200A-SCS - Connecting a LAN Cable

Section 2: Installation Model 4200A-SCS Setup and Maintenance User's Manual
2-4 4200A-908-01 Rev. A December 2020
Connecting a LAN cable
The LAN connectors on the 4200A-SCS are standard RJ-45 connectors intended for use with
unshielded twisted pair (UTP) cable. For best results, use only CAT 5 UTP cables equipped with
RJ-45 connectors to connect your LANs, as shown in the following figure.
If IP addresses are statically assigned, you need to assign a different IP address to each LAN port.
Figure 6: LAN connections