Tektronix MDO4000B Series

Appendix H: List of Beta Commands and Features
Group:
AFG
Syntax:
AFG:MODULation:TYPe {NONe|AM|FM}
AFG:MODULation:TYPe?
Arguments:
NONe - Value set and returned when AFG:RUNMode is not set to MODUlation.
AM - Amplitude Modulation
FM - Frequency Modulation
Examples:
AFG:MODULation:TYPe AM sets the modulation type to Amplitude Modulation.
AFG:RUNMode
Description:
Sets the operating run mode for the AFG.
Conditions:
Beta Command, see conditions of use. Default setting is CONtinuous.
Group:
AFG
Syntax:
AFG:RUNMode {CONtinuous|MODUlation|BURst}
AFG:RUNMode?
Arguments:
CONtinuous - Continuous run mode.
MODUlation -M
odulation run mode specified by AFG:MODUlation:TYPE
.
BURst - Burst mode. Also sets AFG:TRIGger:MODe to BURst.
Examples:
AFG:RUNMode CONtinuous sets the run mode to continuous output.
An existing AFG waveform can be 100% amplitude modulated with a 10 kHz
square wave using the following sequence of commands:
AFG:RUNMode MODUlation
AFG:MODULation:TYPe AM
AFG:MODULation:AM:WAVeform SQUare
AFG:MODULation:AM:FREQuency 10e3
H-6 MDO4000/B/C, MSO/DPO4000B and MDO3000 Series Oscilloscopes Programmer Manual