Command Descriptions
2-94
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
TRG command, or the GET GPIB interface message, or the
USBTMC TRIGGER message.
Miscellaneous
*DDT { <Block> | <QString> }
*DDT?
<Block> or <QString> is a compl ete sequence of program messages.
The messages must contain only valid commands that must be
separated by semicolons and must follow all rules for concatenating
commands (refer to page 2--6). The sequence must be ≤80 characters.
<Block> format is always returned as a que ry response.
*DDT #217ACQuire:STATE RUN<EOI>
Specifies that the acquisition system will be started each time a
*TRG command is sent.
*TRG
DESE
Sets and queries the bits in the Device Event Status Enable Register
(DESER). The DESER is the mask that determines whether or not
events are reported to the Standard Event Status Register (SESR),
and entered into the Event Queue. Refer to the Status and Events
chapter on page 3--1 for more information.
Status and Error
Group
Syntax
Arguments
Examples
Related Commands
Group
To Next Page
Loading...
