Command Descriptions
2- 138
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
HORizontal:MAIn:POSition?
<NR3> is the position in seconds. This value is the difference bet we en
the trigger point and the center graticule. Positive values place the
trigger before the center graticule.
HORizontal:MAIn:POSition 2.0E–6
Sets the main trigger position to 2 s before the center grati cule.
HORizontal:MAIn:POSition?
Might return -1.0E-3, indicating that the main trigger position is
1 ms after the center graticule.
HORizontal:MAIn:SCAle
Sets the time per division for the main time base. This command is
equivalent to setting SEC/DIV when Main is selected from the
Horizontal menu.
Horizontal
HORizontal:MAIn:SCAle <NR3>
HORizontal:MAIn:SCAle?
<NR3> is the time per division. The range depends on the oscillo-
scope model. The acceptable values are in a 1–2.5–5 sequence .
Other values are forced to the closest acceptable value.
HORizontal:MAIn:SCAle 2.5E–6
Sets the main scale to 2.5 s per division.
Arguments
Examples
Group
Syntax
Arguments
Examples
To Next Page
Loading...
