Tektronix TDS210 User Manual

Command Groups
2-38
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
Table 2- 26: Waveform commands
Header D escription
CURVe Transfer waveform data to or from the
oscilloscope
DATa Set or query the waveform data format and
location
DATa:DESTination Set or query the destination for waveforms
sent to the oscilloscope
DATa:ENCdg Set or query the waveform data encoding
method
DATa:SOUrce Set or query the source of CURVe? data
DATa:STARt Set or query the starting point in waveform
transfer
DATa:STOP Set or query the ending point in waveform
transfer
DATa:TARget Same as DATa:DESTination
DATa:WIDth Set or query the byte width of waveform
points
WAVFrm? Return waveform preamble and curve data
WFMPre? Return waveform preamble
WFMPre:BIT_Nr Set or query the preamble bit width of
waveform points
WFMPre:BN_Fmt Set or query the preamble binary encoding
type
WFMPre:BYT_Nr Set or query the preamble byte width of
waveform points
WFMPre:BYT_Or Set or query the preamble byte order of
waveform points
WFMPre:ENCdg Set or query the preamble encoding
method

Tektronix TDS210 Specifications

General

Brand	Tektronix
Model	TDS210
Category	Test Equipment
Language	English