Command Descriptions
2-62
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
CALibrate:STATUS? (Query Only)
Returns the status of the last calibration operation performed (either
self- or factory-calibration) since power up.
Calibration and Diagnostic
CALibrate:STATUS?
PASS indicates that the oscilloscope completed the last calibration
operation without detecting any errors.
FAIL indicates that the oscilloscope detected errors during the last
calibration operation, or that no calibration operations have been
performed since power up.
CALibrate:STATUS?
Might return CALIBRATE:STATUS FAIL, if the oscilloscope failed the
last calibration operation.
CH<x>? (Query Only)
Returns the current oscilloscope vertical settings. The value of <x>
can vary from 1 through 4 for 4-channel instrument s or 1 through 2
for 2-channel instruments.
Because CH<x>:SCAle and CH<x>:VOLts are identical, only
CH<x>:SCAle is returned.
Vertical
CH<x>?
Group
Syntax
Returns
Examples
Group
Syntax
To Next Page
Loading...
Need help?
General
