Command Descriptions
2-66
TDS200, TDS1000/2000, TDS1000B/2000B, TPS2000 Programmer
10 sets the specified oscilloscope channel to 10X attenuation.
50 sets the specified oscilloscope channel to 50X attenuation.
100 sets the specified oscilloscope channel to 100X attenuation.
1000 sets the specified oscilloscope channel to 1000X attenuation.
<NR1>
CH2:CURRENTPRObe 1000
This sets channel 2 to 1000X attenuation.
CH1:CURRENTPRObe?
Might return 10.
CH<x>:INVert
NOTE. You can NOT use t his command with a TDS210 or TDS220
oscilloscope with firmware below V 2.00 and a TDS2CMA
(or TDS2CM) communications module.
Sets or queries the inversion state of the specified oscilloscope
channel. The value of <x> can vary from 1 through 4 for 4-channel
instruments or 1 through 2 for 2-channel instruments.
This command is equivalent to setting the Invert option in the
Vertical channel menus.
Vertical
CH<x>:INVert { ON | OFF }
CH<x>:INVert?
Returns
Examples
Group
Syntax
To Next Page
Loading...
