Section 3 - Configuring the VM700A
VM700A Option 01 (NTSC) & Option 11 (PAL) User Manual
3-11
timed events (periodically scheduled reports and functions) is determined by the
contents of file “My_Events” in the Timed Events subdirectory.
When the VM700A is shipped, all three channel parameters and the Timed
Events parameter are set to System Default.
For a dual-standard VM700A (those equipped with both Option 01, NTSC, and
Option 11, PAL), the Source_Selection~Video file is a little different. For each
channel, it indicates the current standard in effect, along with a separate file from
the Video_Source~Files directory for each of NTSC and PAL.
When the NTSC standard is in effect, the file listed under the NTSC column is
used; when the PAL standard is in effect, the file listed under the PAL standard is
used. To change the standard in effect for a channel, rotate the control knob until
that channel’s line is highlighted (intensified), then select the entry under the
“Video Std.” column by touching it. Rotate the control knob until the desired
standard appears. Touch the Update & Exit soft key to enter the change into the
file.
In Figure 3-4, the current video source (as indicated by the front-panel Source
button) determines which entry is read from the Source_Selection~Video file.
This, in turn, determines which file is read from the Video_Source~Files
directory. This file determines which files to use to get operating information
from each of several directories.
To Next Page
Loading...
Need help?
General
