Tektronix WFM6120 Service Manual

Introduction
Hardware Installation
The waveform monitor is shipped in a wrap-around chassis which covers the
instrument bottom and two sides. A cover is installed on the chassis, and the
rear panel is made up of the module rear panels. You can operate the waveform
monitor in the instrument chassis (the top cover must be installed, for safety
and for prop
er cooling), or installed in an approved portable cabinet or rack
adapter. You can also install the waveform monitor in a custom installation, such
as a console. For installation instructions, refer to the WFM6120, WFM7020,
WFM7120, WFM6100 Opt. MB, WFM7000 Opt. MB, and WFM7100 Opt. MB
Waveform Monitor Quick Start User Manual.
Product Upgrade
To install product enhancements when ordered as a field upgrade, refer to the
instructions included with the kit. When updating hardware it is suggested that the
software be updated too. Software is available a t www.tek.com. The WFM6120,
WFM7020, WFM7120, WFM6100 Opt. MB, WFM7000 Opt. MB, and WFM7100
Opt. MB Waveform Monitor Quick Start User Manual also includes instructions
for updating product software.
Operating Information
For basic operating instructions, refer to the WFM6120, WFM7020, WFM7120,
WFM6100 Opt. MB, WFM7000 Opt. MB, and WFM7100 Opt. MB Waveform
Monitor Quick Start User Manual that shipped with this product. For more
detailed reference information, refer to the Waveform Monitor Online Help. (Press
the Help button and then use the General knob, up/down arrow keys, and SEL to
navigate through the topics.)
In addition, there is context sensitive help to identify the buttons and knobs.
Press the Help button to enable the context sensitive help. Press it again to turn
the context sensitive help off.
Power-On Procedure
1. This product has no power switch; to power it up,
plug it in to a line voltage
source.
2. Wait for the system to complete its power-on self-tests.
Power-Down Procedure
There are two methods to power down the waveform monitor
Power Down –Unplugtheinstrument.
Standby – The instrument can be placed in a low-power standby mode by
touching the Standby power button. This also saves the current instrument state
as the Latest Preset, which can be configured as the Power-up Preset.
1–2 WFM6120, WFM7020, and WFM7120 Waveform Monitors Service Manual

Tektronix WFM6120 Specifications

General

Brand	Tektronix
Model	WFM6120
Category	Monitor
Language	English