Under Configure the Alert Service for WLAN surveillance, click Start to monitor your
managed APs. You are taken to the External Reporting->Alert Service->Alert Recipient
menu with the default setting Event = %  - !!,. You can specify that you
wish to be notified by e-mail if the %  - !!, event occurs.
Click under New Neighborscan on Start, to rescan adjacent AP's. You will receive a warn-
ing that the wireless modules of the access points must also be disabled for a certain peri-
od of time. When you start the process with OK, a progress bar is displayed. The located
AP display is updated every ten seconds.
13.2 Controller Configuration
In this menu, you make the basic settings for the wireless LAN controller.
13.2.1 General
Fig. 62: Wireless LAN Controller->Controller Configuration->General
The Wireless LAN Controller->Controller Configuration->Generalmenu consists of the
following fields:
Fields in the Basic Settings menu.
Field Description
Region Select the country in which the wireless LAN controller is to be
operated.
Possible values are all the countries configured on the device's
wireless module.
13 Wireless LAN Controller Teldat GmbH
160 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
