Field Description
Distribution Policy Displays the type of data traffic selected.
Fields in the Interface Selection for Distribution menu.
Field Description
Interface Select the interfaces that are to belong to the group from the
available interfaces.
Distribution Ratio Enter the percentage of the data traffic to be assigned to an in-
terface.
The meaning differs according to the Distribution Ratio em-
ployed:
• For
*##@3@ is based on the number of distrib-
uted sessions.
• For /) =1, the data rate is the de-
cisive factor.
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu.
Field Description
Route Selector The Route Selector parameter is an additional criterion to help
define a load balancing group more precisely. Here, routing in-
formation is added to the "interface" entry within a load balan-
cing group. The route selector is required in certain scenarios to
enable the IP sessions managed by the router to be balanced
uniquely for each load balancing group. The following rules ap-
ply when using the parameter:
• If an interface is only assigned to one load balancing group, it
is not necessary to configure the route selector.
• If an interface is assigned to multiple load balancing groups,
configuration of the route selector is essential.
• The route selector must be configured identically for all inter-
face entries within a load balancing group.
Select the Destination IP Address of the desired route.
14 Networking Teldat GmbH
208 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
