Field Description
The function is enabled by default.
Create NAT Policy
Specify whether Network Address Translation (NAT) is to be ac-
tivated.
The function is enabled with ,.
The function is enabled by default.
Local IP Address Only if IP Address Mode = *"
Enter the static IP address of the connection partner.
Route Entries
Only if IP Address Mode = *"
Define other routing entries for this connection partner.
Add new entries with Add.
• @  -##: IP address of the destination host or
network.
• '#7: Netmask for Remote IP Address If no entry is
made, your device uses a default netmask.
• %": The lower the value, the higher the priority of the
route (range of values ... ). The default value is .
IP Assignment Pool
Only if IP Address Mode =   -##
Select IP pools configured in the WAN->Internet + Dialup->IP
Poolsmenu. If an IP pool has not been configured here yet, the
message ' & ! appears in this field.
The menu Advanced Settings consists of the following fields:
Fields in the Advanced Settings menu.
Field Description
Block after connection
failure for
Enter the wait time in seconds before the device should try
again after an attempt to set up a connection has failed.
The default value is .
Maximum Number of
Dialup Retries
Enter the number of unsuccessful attempts to setup a connec-
tion before the interface is blocked.
17 WAN Teldat GmbH
298 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
