Teldat bintec R3002 User Manual

Note
Generally, monitoring is not carried out by the terminal but is initiated by the ISP. Your
device then only needs to react correctly to the signals received. This is ensured
without a specific OAM configuration for both flow level 4 and flow level 5.
Two mechanisms are available for monitoring the ATM connection: Loopback Tests and
OAM Continuity Check (OAM CC). These can be configured independently of each other.
Caution
The configuration of OAM requires extensive knowledge of ATM technology and the
way the Teldat devices functions. An incorrect configuration can cause considerable
disruption during operation. If applicable, save the original configuration on your PC.
In the WAN->ATM->OAM Controlling menu, a list of all monitored OAM flow levels is dis-
played.
17.2.3.1 New
Choose the New button to set up monitoring for other flow levels.
Fig. 124: WAN->ATM->OAM Controlling->New
The menu WAN->ATM->OAM Controlling->New consists of the following fields:
Fields in the OAM Flow Configuration menu.
17 WAN Teldat GmbH
312 bintec Rxxx2/RTxxx2

Teldat bintec R3002 Specifications

General

Brand	Teldat
Model	bintec R3002
Category	Gateway
Language	English