Field Description
IP Compression Select whether compression is to be activated before data en-
cryption. If data is compressed effectively, this can result in
higher performance and a lower volume of data to be trans-
ferred. In the case of fast lines or data that cannot be com-
pressed, you are advised against using this option as the per-
formance can be significantly affected by the increased effort
during compression.
The function is enabled with ,.
The function is disabled by default.
Alive Check Select whether and how IPSec heartbeats are used.
A Teldat IPSec heartbeat is implemented to determine whether
or not a Security Association (SA) is still valid. This function
sends and receives signals every 5 seconds, depending on the
configuration. If these signals are not received after 20 seconds,
the SA is discarded as invalid.
Possible values:
• -3" (default value): Automatic detection of whether
the remote terminal is a Teldat device. If it is, ?#
* K<)" (for a remote terminal with Teldat) or
" (for a remote terminal without Teldat) is set.
• ": Your device sends and expects no heartbeat. Set
this option if you use devices from other manufacturers.
• ?# <)" ,&: Your device expects a
heartbeat from the peer but does not send one itself.
• *: Your device expects no heartbeat from the peer, but
sends one itself.
• ?# * K<)": Your device expects a
heartbeat from the peer and sends one itself.
Propagate PMTU Select whether the PMTU (Path Maximum Transfer Unit) is to
be propagated during phase 2.
The function is enabled with ,.
The function is enabled by default.
Teldat GmbH
18 VPN
bintec Rxxx2/RTxxx2 353
To Next Page
Loading...
Need help?
General
