Combination device If an analogue terminal connection of the PBX is set up as a "multi-
functional port" for combination devices, all calls are received, re-
gardless of the service. In the case of trunk prefixes using codes,
the service ID "Analogue Telephony" or "Telefax Group 3" can also
be transmitted, regardless of the configuration of the analogue con-
nection. If 0 is dialled, the service ID "Analogue Telephony" is also
transmitted.
Conference call Performance feature of a PBX: Several internal subscribers can
telephone simultaneously. Three-party conferences are also pos-
sible with external subscribers.
Configuration Man-
ager
Windows application (similar to the Windows Explorer), which uses
SNMP commands to request and carry out the settings of your gate-
way. The application was called the DIME Browser before BRICK-
ware version 5.1.3.
Configuration of the
PBX with the PC
One important prerequisite for the transfer of your configuration to
the PBX is that you have set up a connection between the PC and
PBX. You can do this using the LAN Ethernet connection.
Configuration of the
PBX with the tele-
phone
With some restrictions, you can also program your PBX using the
telephone. For information on programming your PBX using the tele-
phone, please see the accompanying user's guide.
Connection of ana-
logue terminals
The performance features for analogue terminals can only be used
with terminals that use the MFC dialling method and that have an R
or flash key.
Connection of ISDN
terminals
The internal telephone number of the connection, and not the ex-
ternal number (multiple subscriber number) must be entered as the
MSN in the ISDN terminal connected to the internal ISDN bus. See
the user's guide for the ISDN terminals: Enter MSN. Please note
that not all the ISDN terminals available on the market can use the
performance features provided by the PBX via their key interface.
CRC Cyclic Redundancy Check
CTI Computer Telephony Integration. Term for connection between a
PBX and server. CTI enables PBX functions to be controlled and
evaluated by a PC.
D channel Control and signalling channel of an ISDN Basic Rate Interface or
Primary Rate Interface. The D channel has a data transmission rate
of 16 kbps. In addition to the D channel, each ISDN BRI has two B
channels.
Glossary Teldat GmbH
562 bintec Rxxx2/RTxxx2
To Next Page
Loading...
Need help?
General
