EasyManuals Logo
Home>Teldat>Gateway>bintec R3002

Teldat bintec R3002 User Manual

Teldat bintec R3002
622 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #605 background imageLoading...
Page #605 background image
Signalling 1) phones.
V.11 ITU-T recommendation for balanced dual-current interface lines (up
to 10 mbps).
V.24 CCITT and ITU-T recommendation that defines the interface
between a PC or terminal as Data Terminal Equipment (DTE) and a
modem as Data Circuit-terminating Equipment (DCE).
V.28 ITU-T recommendation for unbalanced dual-current interface line.
V.35 ITU-T recommendation for data transmission at 48kbps in the range
from 60 to 108kHz.
V.36 Modem for V.35.
V.42bis Data compression procedure.
V.90 ITU standard for 56 kbps analogue modems. In contrast to older
V.34 modems, data is sent in digital form to the client when the V.90
standard is used and does not need to be first converted from digital
to analogue on one side of the modem (provider), as was the case
with V.34 and earlier modems. This makes higher transmission
rates possible. A maximum speed of 56 kbps can be achieved only
under optimum conditions.
Vanity Letter dialling
VDSL Very high bit rate digital subscriber line (also called VADSL or BD-
SL).
VID VLAN ID
VJHC Van Jacobson Header Compression
VLAN Virtual LAN
VoIP Voice over IP
VPN Virtual Private Network
VSS Virtual Service Set
WAN Wide Area Network
WAN interface WAN interface
WAN partner Remote station that is reached over a WAN, e.g. ISDN.
Teldat GmbH
Glossary
bintec Rxxx2/RTxxx2 591

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Teldat bintec R3002 and is the answer not in the manual?

Teldat bintec R3002 Specifications

General IconGeneral
BrandTeldat
Modelbintec R3002
CategoryGateway
LanguageEnglish

Related product manuals