Telecom Behnke 5 Series Instructions

Code Parameter Conrmation
52
Upon entering configuration step code 52 and the corresponding
no. of the message to be played, the device will automatically play
the message in question. Playing the message will automatically
stop after the message has elapsed. You may also stop the
message playing by pressing the # key.
Important: You may only play the long messages no. 7, 8 and 9
after you have previously set a corresponding amount of long
messages under configuration step code 50.
58
Voice message during direct call: Default setting: 0 0 0
x [beep] y [beep] z [beep]
x = Voice message before the direct call is dialled
y = Voice message while waiting for the call to be picked up
z = voice message after the called party has picked up
The following entries are permitted for x; y and z:
0 = No voice message
1 = Play voice message no. 1
…
9 = Play voice message no. 9
Use this configuration step to set up to 3 voice messages to be played
during a direct call (dialling of a number previously stored in the device).
During this configuration step, the device requires the entry of three
digits from 0 to 9 to specify the voice messages to be played. The first
cypher determines the voice message to be played prior to dialling the
telephone no., e.g. a message like “Direct call activated” (entering the
digit ‘0’ means that no message will be played). The second cypher
determines the voice message to be played repeatedly while the
connection is being established, e.g. a message like "Please hold the
line." Establishing connection." This message will only be played to the
called party, e.g. a message like “Call from your intercom system.” The
third cypher determines the voice message to be played once the called
party picks up the call. This configuration step will affect all direct calls.
Example:
Provided that you recorded the following voice messages via
configuration step code 51:
1. Voice message (51-1): "Direct call activated."
3. Voice message (51-3): "Please hold. Establishing connection."
9. Voice message (51-9): „Call from the intercom system.“
Making the following entry will result in these messages to
be played during a direct call:
58 1 [beep] 5 [beep] 9 [beep] #
In case the message “Direct call activated.” should not be played,
make the following entry:
58 0 [beep] 5 [beep] 9 [beep] #
#
Configuration and Set-up
54 www.behnke-online.com
GB
Instructions for Series 5 / 10

Telecom Behnke 5 Series Specifications

General

Brand	Telecom Behnke
Model	5 Series
Category	Intercom System
Language	English