EasyManua.ls Logo

Teledyne 500D - 100 DX Technical Specifications

Teledyne 500D
344 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
D Series Syringe Pumps
Section 1 Introduction
1-6
Table 1-5 100DX Technical Specifications
CYLINDER CAPACITY 102.93 ml
POWER REQUIREMENTS
a
(Mains voltage line cord is a
“Disconnect Device”)
100 ± 10 VAC, 1.5 A maximum
117 ± 12 VAC, 1.5 A maximum
234 ± 23 VAC, 0.75 A maximum
LINE FREQUENCY 50 or 60 Hz
LINE VOLTAGE NOISE TOLERANCE 1.7
nominal rms line voltage, 10 µsecond pulses, any phase
angle, random or repetitive
DIMENSIONS PUMP CONTROLLER
Width: 27.18 cm 27.18 cm
Depth: 46.74 cm 30.48 cm
Height: 101.09 cm 13.59 cm
WEIGHT PUMP CONTROLLER
32.8 kg 2.96 kg
FLOW RATE RANGE 0.01 µl/min to 50 ml/min (for any pressure up to 689.5 bar)
FLOW RATE ACCURACY
b
± 0.3% (maximum 0.25 µl/min seal leakage)
FLOW RATE DISPLAY RESOLUTION 0.01 µl/min (1.0 µl/min in Constant Pressure Mode)
ANALOG OUTPUT ACCURACY
c
± 1% of selected range
DISPLACEMENT RESOLUTION 9.65 nl /step
REFILL TIME 1.72 minutes
REFILL OR DEPRESSURIZATION RATE 0.01 µl/min to 60 ml/min at any pressure from 0 to 689.5 bar
PRESSURE RANGE 0.6895 to 689.5 bar
PRESSURE ACCURACY ± 0.5% of full scale at constant temperature
PRESSURE REPEATABILITY
d
± 0.5% of full scale within 48 hours at constant temperature
ZERO PRESSURE DRIFT ± 0.25% of full scale within 48 hours at constant temperature
PRESSURE DISPLAY RESOLUTION 6.895 kPa
AMBIENT TEMPERATURE RANGE 5 to 40°C
TEMPERATURE DRIFT ± 0.0.12% of full scale/°C
HUMIDITY 95% maximum
DEAD (HEADSPACE) VOLUME
e
1.30 ± 0.020 ml
POLLUTION DEGREE 2
INSTALLATION CATEGORY II
MAXIMUM ALTITUDE 2000 m
a. Underwriters Laboratories (UL) has certified all D Series Pumps with the exception of the 100 VAC versions.
b. Using water at 137.9 bar and a temperature controlled environment at 30°C.
c. The analog output is an optional accessory.
d. Pressure repeatability specification is based upon re-zeroing pressure transducer every 48 hours. Refer to sub-section
ZERO PRESS in Section 3 of the manual for re-zeroing procedure.
e. Volume in and above the piston seal, head clearance at automatic shutoff, and inlet and outlet ports to the fittings.
Factory Set
}

Table of Contents