D Series Syringe Pumps
Section 1 Introduction
1-20
Figure 1-9 Syringe pump cylinder cap: Attach to pressure
transducer connector on back of pump.
CAUTION
The pressure transducer cable length is always 6 feet (1.8m).
Never attempt to extend the length of this cable.
Extension cable for pump controller connect
Hazloc pumps:
10 ft (3m)
50 ft (15.24m)
68-1020-505
68-1020-506
D Series Pumps
only:
10 ft (3m)
50 ft (15.2m)
68-1020-210
68-1020-214
RS232 Cable for computer serial control of a sin-
gle controller. 9 pin to 25 pin.
6 ft (1.8m) 480-7996-00
RS232 Cable for computer serial control of two
controllers. 9 pin to two 25 pin.
6 ft (1.8m) 68-1020-198
RS232 Extension cable for computer serial con-
trol of three or more controllers. Connects to
above cable. 25 pin to two 25 pin.
6 ft (1.8m) 68-1020-180
Transducer cable,
6ft (1.8m)
Transducer Cap
assembly for the
30D/65D
To Next Page
