Teledyne 500D - Packages and Parts; Fluid Fittings

D Series Syringe Pumps
Section 2 Fluid System Connections and Accessories
2-14
Removing the pump
cylinder for 30D
Note
For the 30D pump remove the cylinder cap assembly ONLY.
Do not remove the cylinder from the cylinder block.
1. Run the pump until the control display shows CYLINDER
EMPTY.
2. Remove the fluid fittings from the sides of the pump cap
(Figure 2-13).
Figure 2-13 Fluid fittings
Table 2-6 Packages and Parts
Item Description Part Number
Temperature control jacket packages for:
65D, 65DM,100DM,
100DX, 260D
30D
500D, 500HPx
500SP
1000D
68-1247-047
68-1267-001
68-1247-057
68-1247-115
60-5364-199
Temperature control jacket assembly:
65DM, 100DM, 100DX,
260D
30D
500D, 500HPx
1000D
60-1248-053
60-1268-020
60-1248-099
60-1248-183
Key
3
32" socket
490-0031-54
Inlet/outlet connector (2) 209-0161-00
Installation procedure 60-1242-183
O-ring (2):
100DM, 100DX, 260D
30D, 65D, 65HP, 500D,
500HPx
1000D
202-2062-23
202-2062-11
202-2062-35
Transducer Connector
Fluid Fittings