D Series Syringe Pumps
Section 3 Basic Programming and Operation
3-3
3.2.4 Selecting Operating
Parameters
There are four ways to program the system from a menu screen.
Menu Selection – The number keys are used to select from
listed menu items.
Softkey Selection – The softkey programming options appear
on the fourth line of the screen. To either toggle or select an
option, press the softkey, A-D, directly below that option.
Keypad Selection – The programming keys are located on the
left side of the keypad. The pump mode, limits, and refill are all
options that may be selected from the keypad.
Value Selection – The number keys are used to enter all
numeric values required for pump operation. When a numeric
value is required, a message will blink, prompting you to enter
an appropriate value.
3.3 Main Menus There are four main menu screens. Access Menu 1 by pressing
MENU. To move forward and back between Menus 1, 2, 3 and 4, or
to return to the run screen, use softkeys A (MORE) and D (PRE-
VIOUS/RETURN).
Use the number keys to select a menu option. Selecting a menu
option displays the programming parameters for that option in
menu form.
Note
To exit a menu when multiple pumps are connected, press the
STORE,RECALL,CLEAR ENTRY OR MENU key.
3.4 Menu One Menu 1 provides programming options for units of measure,
pump selection, refill settings, power failure response, system
reset, and display contrast adjustment.
To save all settings and return to the main menu, press RETURN
(D).
Figure 3-1 Menu 1 program selections
3.4.1 Flow and/or Pressure
Units of Measure
Displayed units are user-selectable by selecting menu 1 item 1.
Figure 3-2 Units menu
1. UNITS
2. SELECT PUMP
3. REFILL
MORE
4. POWER FAILURE [STOP]
5. SYSTEM RESET
6. DISPLAY CONTRAST
RETURN
A
B
C
D
1.
PRESSURE UNITS=___________FLOW UNITS=__________
AT M
2.
BAR
3.
4.
5.
6.
7.
8.
PSI
kPA
mL/MIN
mL/HR
µL/MIN
PREVIOUS
µL/HR
To Next Page
Loading...
