5-2 TELEDYNE BENTHOS
User’s Manual P/N M-270-10, Rev. B
Flow Control: None
Operation mode: DS-7000 Deck Box Emulation
Sending Commands and Receiving Data
For commands to be sent and for round trip travel times and status
information to be received, the UDB-9000 must be on and an "@" prompt
must be displayed on the monitor of the PC. To turn on the UDB-9000, switch
the OFF/ON switch to ON.
There are two types of commands, commands that write and commands that
read. Every command requires the entry of a two-character mnemonic. For a
command that writes, the mnemonic must be followed by an equals sign (=)
or a space, followed by one or more letters or numbers in accordance with a
specified format, and then an Enter. For a command that reads, the
mnemonic must be followed by an Enter. For both write and read commands,
the results are displayed after the command is entered.
As a write command example, to set the transmit frequency, enter the
command
TX=7.25 or TX 7.25
and then press Enter. The new transmit frequency is displayed:
TX=7.25
As a read command example, to display the transmit frequency, enter the
command
TX
and then press Enter. The transmit frequency is displayed:
TX=7.25
Serial Commands
The read commands and their syntax and displayed response are listed in
Table 5-1. The write commands and their syntax and displayed response are
listed in Table 5-2.
To Next Page
Loading...
Need help?
General
