UDB-9000 Universal Deck Box - UDB-9000-M (Portable) and UDB-9000-MR (Rack Mount) Configurations 5-5
5 Operation using Serial Interface Commands
Table 5-2 DS-7000 Write Commands
COMMAND NAME SYNTAX RESPONSE
Receive Pulse Duration RD #.## or RD=#.## RD= #.## where x is 6.25 or 12.5 in milliseconds
Receive Sensitivity RS ### or RS=### RS=### where ### is 010 to 500
Date DA mm/dd/yy or DA=mm/dd/yy DA=mm/dd/yy
Time TI hh:mm:ss or TI=hh:mm:ss TI=hh:mm:ss
Transmit Frequency TX ##.## or TX=##.## TX=##.## where ##.## is 07.00 to 15.00 in .25 incre-
ments
Display Lockout DL c or DL=c DL=c where c is E for enabled or D for disabled
Power Output PO # or PO=# PO=# where # is 0 through 8
Repeat Interval RI ##.# or RI=##.# RI=##.# where ##.# is 03.5 through 35.0
Repeat Ping Status RP c or RP=c RP=c where c is E for enabled or D for disabled
Silent Ping SP c or SP=c SP=c where c is E for enabled or D for disabled
Ping Duration PD ##.# or PD=##.# PD=##.# where ##.# is 10.0 to 25.0
Ping Lockout PL ### or PL=### PL=### where ### is 000 to 995 in steps of 5
Turnaround Compensation TC ##.# or TC=##.# TC=##.# where ##.# is 00.0 to 99.9 ms
Ping Command PI or PI <id> or PI=<id> PI=<id> tx.ff c mm/dd/yy hh:mm:ss where <id> is any
string, tx.ff is the transmit frequency, and c is S for
silent ping or N for normal ping. ## will be 00 if no
identifier was specified.
Frequency Filter Status FS c or FS=c FS=c where c is E for enabled or D for disabled
Frequency Filter FF ##.## … ##.## or FF=##.##… ##.##
or
FF NONE or FF=NONE
FF=##.##… ##.## where ##.## is 07.00 to 15.00 in .25
increments.
or
FF=NONE
To Next Page
Loading...
Need help?
General
