ADR-7000 / SAVER-7000 / GUARD-7
© 2017 – Telefire Fire & Gas Detectors Ltd Revision 0.98 October 2017
– Page 16 of 87 –
Dual Switch Interface Module configured
as a single address
1
Dual Switch Interface Module configured
as two addresses
2
Multi Input Module configured as a single
address
2
Multi Input Module configured as two
addresses
2
Multi Input Module configured as four
addresses
2
Multi Input Module configured as eight
addresses
2
High power output module configured as
a single address
3
High power output module configured as
two addresses
3
High power output module configured as
three addresses
3
Two-Channel Input Module configured as
a single input
4
Two-Channel Input Module configured as
two inputs
4
Flow Switch Interface Module
Eight-Channel Input Module
Three-Channel I/O Module – as a single
output
3
Three-Channel I/O Module in
2-address configuration
3
Three-Channel I/O Module – in
3-address configuration
3
Eight-Channel Output Module
The ADR-705 can be configured as a single-address, or two-address module.
The ADR-71x can be configured as a single-address, or two-address module (factory default for
ADR-712) or a four address or eight address module (factory default for ADR-718).
The ADR-723 and ADR-823A can be configured as a single-address, two-address, or three-
address module as required.
The ADR-812A can be configured as a single-address or two-address module as required.
To Next Page
Loading...
