Telefire GUARD-7 - ADR-7000 Control Panels

ADR-7000 / SAVER-7000 / GUARD-7
© 2017 – Telefire Fire & Gas Detectors Ltd Revision 0.98 October 2017
— I —
Table of Contents
1 INTRODUCTION ............................................................................................ 1
1.1 SAVER-7000 AND GUARD-7 DIFFERENCES ................................................... 2
2 ADR-7000 CONTROL PANELS .................................................................... 3
2.1 MAIN BOARD – ADR-7021 .............................................................................. 4
2.2 SLC LINE CARD – ADR-7002 ......................................................................... 4
2.3 KEYBOARD AND DISPLAY MODULE – ADR-7003 .............................................. 5
2.4 POWER SUPPLY ............................................................................................. 5
2.5 ZONE ALARM MODULE – ADR-7000ZM .......................................................... 5
2.6 NETWORK COMMUNICATION MODULE – LON-7000 .......................................... 5
2.7 TCP/IP MODULE – NET-7000 ........................................................................ 6
2.8 LOOP EXPANSION CARD – ADR-7001EM1 – ADR-7000 ONLY ......................... 7
2.9 REMOTE ANNUNCIATOR – RM-7000 ................................................................ 7
2.10 ACCESS LEVELS ............................................................................................ 8
3 WORK STATES – ALARM, FAULT, SUPERVISORY, DISABLEMENT,
AND TEST MODES ..................................................................................... 10
3.1 NORMAL (QUIESCENCE) STATE ..................................................................... 10
3.2 ALARM STATE .............................................................................................. 10
3.3 FAULT STATE ............................................................................................... 12
3.4 SUPERVISORY STATE ................................................................................... 12
3.5 DISABLEMENT STATE ................................................................................... 13
3.6 TEST STATE................................................................................................. 14
3.7 STATUS STATE ............................................................................................ 14
4 INSTALLATION ........................................................................................... 15
4.1 PRE-INSTALLATION PLANNING ....................................................................... 15
4.2 CABLE PLANNING ......................................................................................... 17
4.3 WIRING ....................................................................................................... 21
4.4 INSTALLATION OF DETECTORS, I/O MODULES, AND OTHER MODULES ............. 21
4.5 POST-INSTALLATION ..................................................................................... 27
5 AUTOMATIC EXTINGUISHING ................................................................... 30
5.1 EXTINGUISHING OUTPUT AND EXTINGUISHING CONTROLLER ........................... 30
5.2 MANUAL ACTIVATION .................................................................................... 30
5.3 EXTINGUISHING DELAY ................................................................................. 30
5.4 EXTINGUISHING DISCONNECT ....................................................................... 31
5.5 EXTINGUISHING NOTIFICATION AND ACTION TO PERFORM AFTER RELEASE ...... 31