TELEVAC CC-10 User Manual (English)

Need help?

Do you have a question about the TELEVAC CC-10 and is the answer not in the manual?

TELEVAC CC-10 Specifications

General

Brand	TELEVAC
Model	CC-10
Category	Measuring Instruments
Language	English

Summary

1.0 Introduction and Safety Instructions

1.0.1 Product Overview

Provides a general overview of the CC-10 vacuum gauge and controller.

1.2 Sensor Technology

Explains the two sensor types used: crystal and cold cathode.

1.3 Safety Instructions

2.0 User Controls

2.1 Front panel

Identifies and describes the controls and indicators on the front of the CC-10.

2.2 Rear panel

2.3 Sensor

3.0 Specifications

4.0 Operation

4.1 Starting the measurement

Guides on how to connect and start the CC-10 for vacuum measurement.

4.2 Locking parameters

Explains how to enable/disable the parameter lock function to prevent changes.

4.3 Display modes and mode changing

Describes how to navigate through different operational modes of the CC-10.

4.4 Set Point

4.5 Explanation of each mode

Crystal gauge atmospheric pressure adjust mode

Crystal gauge zero adjustment mode

Analog output setting mode

Pressure unit selection mode

Communication setting mode

Crystal sensor property set mode

5.0 Analog output

5.1 Log Output

Details the logarithmic analog output signal characteristics.

5.2 Combined Output

6.0 Digital Interface

6.1 Communication Specification

Lists the EIA RS-485 communication parameters and specifications.

6.2 Command Explanation

Explains the commands used for communication with the CC-10.

6.3 Command Format

C (control) command

S (status) command

Error response

7.0 Maintenance

7.1 Removing the sensor

Step-by-step instructions for safely removing the sensor from the CC-10.

TELEVAC CC-10 User Manual

Table of Contents