MA365 • Rev. A2 75
Tellabs
®
6325 Edge Node A Packing Instructions
A Packing Instructions
Overview This appendix describes the recommended procedures to follow when pack-
ing modules for shipment.
Use original packing
material
It is recommended to use the original packing material from the factory. But
if the material is not available then follow the instructions here when packing
modules for shipment.
Required materials If you do not have the original packing material, then the following materials
are required for packing the module.
• Antistatic bag (antistatic inner layer and metal coated outer layer) with a
suitable size
• Carton-box with a suitable size
• Foam supporting pad with dimensions that fit the box.
To pack the module Follow the instructions below when you are packing the module before ship-
ment.
Step Action
1
Put an antistatic bracelet on your wrist, and connect the bracelet to
ESD ground on the workplace.
Note: Make sure that the workplace, on which you are connecting the
bracelet, is correctly ESD grounded.