NET-PATH Installation and Operation Guide
Page 3-11
MODEMCOUNTRY MODEMCOUNTRY PhysicalInstance
EnumCode
Examples:
MODEMCOUNTRY 2 4
MODEMCOUNTRY 2 5
Sets the Country Code for the modem. This
command only works with international modems.
PhysicalInstance = 1 or 2
EnumCode = Country Code for the Modem: 1-33.
See Table 4-1 and Table 4-2.
Note: When changing the country code using the
MODEMCOUNTRY command, the remote agent
will not display on its LCD the * (asterisk)
character next to the country code you selected
until you reboot the remote agent.
MOVE MOVE FileSpec DirSpec
Example:
MOVE “File1” “Temp Dir”
Moves files.
FileSpec = original file to move
DirSpec = final location of file
NDPOLL NDPOLL MEDIA:Media TYPE:FileType
HOST: HostName [LAYOUT:LayoutName]
Examples:
NDPOLL MEDIA:FLASH TYPE:
IRISnGEN HOST:MyHost
NDPOLL MEDIA:RAM TYPE
HOST:*LAYOUT: “IRISnGEN
Polling Layout”
Non-destructive poll. Displays the results of the
poll on the screen.
Media = FLASH or RAM
FileType = name of file that controls maximum
file size and file handling
HostName = name of host attached to NET-PATH
Layout = name of called layout that specifies the
format of the record
Note: When entering strings—for example,
HostName—surrounding quotes are not required.
However, when a name contains spaces, the
quotes are required.
Asterisk (*) in place of the host name denotes
polling of shared data as opposed to a specific
host.
PINGHOST PINGHOST HostName Count Delay
Example:
PINGHOST “MyHost” 3 30
Pings a specified Host.
HostName = name of host attached to the remote
agent
Count = number of ping requests to send
Delay = timeout to wait for each reply
Note: When entering strings surrounding quotes
are not required. When a name contains spaces,
quotes are required.
PINGIP PINGIP IPAaddress Count Delay
Example:
PINGIP 172.16.3.24 3 30
Pings a specified IP address.
IPAddress = the IP address of a device on your
network
Count = number of ping requests to send
Delay = timeout to wait for each reply
PROMPT* PROMPT PromptText
Example:
PROMPT NET-PATH
Change the command line prompt.
PromptText = the text that displays on the remote
agent’s command line
Table 3-1: NET-PATH Commands
To Next Page
Loading...
Need help?
General