94
Sidekick
®
Plus Test Set
9. Select the appropriate Vectoring mode:
• Disabled: The modem will not respond to
Vectoring commands.
• Friendly: The modem will respond to Vectoring
commands but not enable Vectoring. This allows
the modem to be compatible with Vectoring
DSLAMs but it will not benefit from increased
bit rates.
• Enabled: The modem will respond and enable
Vectoring commands.
Note: The Vectoring status can be viewed in the
Connection Info screen during modem synchronizing.
10. Enter the WAN setup page if upper layer testing is
needed by pressing the F4 key until “WAN Setup”
is highlighted. All fields in this screen need to be
correct for the modem to authenticate and provide
“Upper Layer” information such as Ping and FTP
information.
To Next Page
Loading...