Tenda W15-Pro - Page 78

Document version: V1.0
71
Parameter
Description
Management VLAN
It specifies the ID of the AP management VLAN.
After changing the management VLAN, you can manage the AP only after connecting
your computer or AP controller to the new management VLAN.
Trunk Port
It specifies the LAN port used as a trunk port of the AP. The default value is LAN0.
Traffic of all VLANs can pass through a trunk port.
If the QVLAN function is enabled, at least one LAN port needs to be set as a trunk port.
Wired LAN Port
It specifies the LAN ports of the AP, including LAN0 and LAN1.
⚫
LAN0: PoE power supply, data transmission multiplexing port of the AP
⚫
LAN1: data transmission port of the AP
LAN ports not set as a trunk port can be seen as an access port. You can set a VLAN ID
for it.
2.4 GHz SSID
They specify the currently enabled SSID(s) over the 2.4 GHz/5 GHz band of the AP, and
the VLAN IDs corresponding to SSIDs.
After the QVLAN function is enabled, the wireless ports corresponding to SSIDs
function as access ports. The PVID of an access port is the same as its VLAN ID.
5 GHz SSID
VLAN ID