Introduction
1-3
PRODUCT IDENTIFICATION NUMBER - PLATE LOCATION
Information regarding the machine model, code and chassis serial number is
found on the unit serial number plate on the rear right of the front frame. The
machine model and serial number should always be referenced in any
correspondence with your dealer or factory.
While reading this manual you will notice references to controls and
equipment which may not be found on all machines. It is important that you
know your machine and its equipment and how to operate it properly.
There is a dealer serving every part of the world where these products are
sold. Your dealer is ready to provide you with any additional information
needed and should be consulted for additional publications for this machine.
When carrying out repairs, alterations or fitting attachments, it is important
that only genuine spare parts are used to ensure the operating safety of the
machine is not impaired.
It is only by using genuine parts that the technical requirements stipulated by
the manufacturer can be maintained.
If a General Operating Approval is issued for this machine, it may be
considered null and void if non-genuine parts are used.
To Next Page
Loading...