Controls and Operating
3-45
Displaying Diagnostic Fault Codes
Diagnostic codes can be displayed on the gear shift lever display. To
access the diagnostic code sequence, press the Display Mode button
twice on the gear shifter. Each code consists of 4 sequential elements;
each being either 1 or 2 characters. The display for each code will repeat
continuously until the next code is displayed (if present). To display the
next code if present, press the mode button. The following cycle illustrates
the display cycle:
• d1 Code list position (d1 newest, d5 oldest)
• P
• 27
• 14
• Code repeats until the next code (d2) is accessed by pressing the mode
button
Clearing Diagnostic Codes
• To clear active codes, press and hold mode button for 3 to 5 seconds.
• To clear inactive codes, press and hold mode button for
8 to 10 seconds.
Exiting Diagnostic Mode
Any of the following methods may be used to exit the diagnostic
display mode:
• Momentarily press the display mode button.
• Move the gear shift lever to any other position than the one selected
when the diagnostic display mode was activated.
• Wait until time out (approx. 10 minutes). The system automatically
returns to normal operating mode.
• Turn off the vehicle - illuminating power to transmission ECU.
To Next Page
Loading...