Safety
2-8
Pre-Starting
• If the engine is to be started and run indoors, ensure proper
ventilation to remove deadly exhaust gases.
• Always perform 'Pre-Starting Inspection' instructions described in
Section 4 to ensure the machine is ready for operation.
• Always walk around the machine to make sure no-one is working
on, underneath or close to the machine before starting the engine
or operating the machine.
• Adjust, secure and latch the seat and fasten the seat belt before
starting the machine.
• Sound the horn before starting the engine or beginning to move
the machine; two blasts for forward and three blasts for reverse.
Starting
• Do not start the engine or operate any control if there is a 'DO
NOT OPERATE' or similar warning sign attached to any control.
• Use jumper cables only as recommended. Improper use can
result in battery explosion or unexpected machine motion.
• Always obey 'Starting the Engine' instructions described in Sec-
tion 4.
• Do not bypass the machine’s neutral-start system. The neutral
start system must be repaired if it malfunctions.
• Start and operate the machine only from the operator’s seat.
Operating
• Ensure all cab glass, mirrors and light lenses are clean during the
machine operation for maximum visibility. Ensure mirrors are
properly set / positioned.
• Always keep the cab floor clear of anything that could restrict full
operation of the pedals.
• Always make sure all gauges, warning/indicator lights and
controls are working properly before operating the machine.
• Always perform 'Pre-Operating Checks' described in Section 4to
ensure the machine is ready for operating.
• Always wear seat belts when operating the machine.
• Do not operate if any personnel enter the immediate work area.
To Next Page
Loading...