Safety
2-4
SAFETY
General
• Read this operations manual and learn the operating
characteristics and limitations of the machine. Know what
operating clearances the machine requires.
• Read and understand all the safety signs prior to operation.
• If the safety signs are obstructed by dirt or debris, clean them
using mild soap and water prior to operation.
• If the safety signs are damaged or illegible, replace them
immediately, prior to operation.
• Read the AEM Safety Manual and follow the recommended
safety precautions.
• Know clearances of all side and overhead obstructions such as
wires, bridges, etc., for operating safely.
• Be especially aware of overhead power lines.
• Always know all traffic rules, signs, flags and hand signals used
on the job and know who has the responsibility for signalling.
• Be aware of operating hazards that weather changes can create
on the job. Know proper procedures to follow when a severe rain
or electrical storm strikes.
• Never attempt to operate or work on a machine when not feeling
physically fit.
• Know what safety equipment is required and use it. Such
equipment may be: Hard hat, safety glasses, reflector type vests,
respirators and ear plugs.
• Never wear loose clothing, rings, watches, heavy gloves etc., that
might catch levers and controls and cause loss of control.
• Keep hands and controls free from water, grease and mud to
assure nonslip control.
• Handle fuels and lubricants carefully and clean up spills to avoid
fire and slipping hazards.
• Clean any mud, grease or oil from controls, handrails, ladders
and decks. Lash necessary tools securely and remove all loose
items before operating the machine. Never rush. Walk, do not
run.
• Never carry more than one passenger and only in the passenger
seat.
To Next Page
Loading...