Introduction
TA9 & TA10 Dumper 0803-3 December 2010
Service or Spares Enquiries
Please state the vehicle type and the Vehicle Identification
Number when making enquiries or orders and in all written
correspondence.
The Vehicle Identification Number is stamped on a plate (A)
located on the front of the right hand wing.
Warranty and Maintenance
The warranty period for the machine, under normal
circumstances, covers the first 12 months. This period begins
the day the machine is handed over or put into operation.
The machine must be used correctly and serviced to the
manufacturers recommendations.
The correct grades of fuels, lubricants and coolants must be
used at all times and must be new and clean when added to the
machine. Failure to follow these rules may lead to failure of the
machine.
Servicing and repairs should be carried out by the dealers staff
who will be trained and experienced in the necessary skills for
successful maintenance of the machine.
Only genuine TEREX spare parts must be used when the
machine is serviced or repaired.
All claims during the warranty period will only be accepted if
the recommended maintenance and service work has been
carried out at the specified intervals.
It is important regular maintenance and service work is carried
out after the warranty period has expired to ensure the machine
is in good working condition and does not cause unnecessary
downtime and expense.
Modifications to this machine and/or changes to the
specification which have not been approved by the factory, will
invalidate the machines warranty and possibly your own
insurance cover.
Official documents (European Community only)
CE mark
The Machinery Safety directive is intended to harmonise all the
machinery safety regulations throughout the community so that
there will be no technical barriers to trade.
Compliance with the essential safety requirements of the EEC
directives 2006/42/EC (machinery), 2000/14/EC (Noise) and
2004/108/EC, permits companies to CE mark their products.
The directive affects almost every equipment supplier and user
in the community and in particular, applies to this type of
machine.
The regulations require that potential hazards from machinery
are properly addressed and guarded against.
The EC declaration of conformity is a requirement of CE
marking. The declaration for this machine follows.
To Next Page
Loading...
Need help?
General
