Installation
TA9 & TA10 Dumper 0803-3 December 2010 4-2
Pre-Start Checks
Before putting the machine into service:
• Check the following fluid levels:
- Oil levels in engine and both axles.
- Hydraulic oil and fuel levels using tank top level gauges.
- Brake fluid level in reservoir located under floor plate.
- Battery electrolyte level.
- Coolant level in radiator.
Recommended lubricants are detailed in the Maintenance
section of this manual.
• Check tyres are inflated to correct pressure.
• Check all instruments alarm buzzers and warning lights
function correctly.
• Check all lights and road traffic indicators (if fitted) function
correctly.
Note: When filling fuel tank make sure the tank is filled when
the engine is cold and the machine is in a well ventilated area,
with the engine stopped using clean fuel and container. It is
advisable to fill the tank at the end of a working session to
prevent condensation forming in the tank during long periods of
inactivity, e.g. overnight.
Check for adequate ventilation if the machine is to be started or
run in a building etc.
b
When Refuelling Beware of Naked Flames, Grinding
Sparks etc.
To Next Page
Loading...
