Description
TA9 & TA10 Dumper 0803-2 November 2009 5-18
Flashing Beacon
The beacon is provided to warn people of the dumpers presence.
The Flashing Beacon (A) is fitted to the machines ROPS (D)
and is controlled by switch (B).
The Flashing Beacon is easily removed to prevent theft or
vandalism by slackening nut (C) and lifting the beacon of its
mounting stem (E).
When the beacon has been removed, the top of the mounting
stem is covered by pulling the rubber stem cap (F) over the
mounting stem (E).
Storage instructions
To help prevent damage, theft and vandalism the flashing
beacon (G) can be removed from its working position on the
ROPS and stored inside the lockable engine compartment when
not required.
It is held in position on the pin by tightening nut (H).
Flashing Beacon
To Next Page
Loading...
