Terrasat IBUC - IBUC Systems: Service and Maintenance; Service and Maintenance; Fault Isolation

IBUC Operation Manual
Terrasat Communications, Inc.
Rev. A
v
Table 4-3 IBUC Power Connector J3 Pin Assignments.......................... 4-8
Table 4-4 PSUI Connector Schedule...................................................... 4-9
Table 4-5 PSUI AC Power Connector J1 Pin Assignments.................... 4-9
Table 4-6 PSUI DC Output Connector J2, Pin Assignments .................. 4-9
Table 4-7 PSUI Fan Connection Pin Assignments ............................... 4-10
Table 4-8 IFU Connector Schedule ...................................................... 4-10
Table 4-9 Recommended Test Equipment........................................... 4-14
Table 6-1 LED Alarms ............................................................................ 6-2
Table 6-2 IBUC Data Packet Byte Configuration.................................... 6-6
Table 6-3 Table of BUC Commands....................................................... 6-7
Table 6-4 Response to BUC Commands 0x01, 0x02, 0x03,
0x04, and 0x08...................................................................... 6-8
Table 6-5 Response to BUC Commands 0x05, 0x06 (when Data
Byte 1 of command message =0x00) .................................... 6-9
Table 6-6 Response to BUC Command 0x06 (when Data
Byte 1 of command message=0x01) ..................................... 6-9
Table 6-7 Response to command 0x07.................................................. 6-9
Table 6-8 Response to command 0x09................................................ 6-10
Table 6-9 IBUC M&C Command Set.................................................... 6-12
Table 6-10 Alarm Flags ........................................................................ 6-28
Table 7-1 1+1 Interface Module............................................................ 7-13
Table 7-2 RS232, HHT & Alarm Connectors J1 and J8 Pin
Assignments......................................................................... 7-14
Table 7-3 M&C Interface Connectors J2 and J4, Pin Assignments ...... 7-14
Table 7-4 User Interface Connector J3, Pin Assignments.................... 7-15
Table 7-5 RX 1+1 Interface Module...................................................... 7-17
Table 7-6 User Interface Connector J1, Pin Assignments.................... 7-18
Table 7-7 Power Connectors J2 and J3, Pin Assignments................... 7-18
Table 7-8 “Y” Adapter Connector Schedule.......................................... 7-19
Table 7-9 Recommended Test Equipment........................................... 7-21
Table 7-10 RX 1+1 Command Set………………………………………...7-41
Table 7-11 Alarm Flags ........................................................................ 7-56
Warnings
Failure to observe all Warnings and Cautions may result in personnel injury and/or
equipment damage not covered by the warranty.
Follow standard Electrostatic Discharge (ESD)
procedures when handling the Terrasat
Equipment.