17
Function Key Display
CLINOBEVEL 2 is ready to
measure with display set to
zero based on the centre of
gravity as per chapter 6.1
CLINOBEVEL 2 is ready to
measure with display set to
zero based on given angle
α = 6°00’00” that is equal
to the inclination against the
centre of gravity
Initiate
« Temporary
zero-setting »
Select a given angle α that
differs from the orientation
against the centre of gravity,
e.g. + 6°00’00”
Activate temporary
correction value
(PRESET value)
The displayed value corresponds to the measu-
red value of the inclinometer less the manually
modified ZERO-OFFSET value and less the va-
lue of REL ZERO OFFSET (PRESET)
To Next Page