TESTO 330-1 - Memory and Location Operations; Creating New Locations; Ordering Location Lists (Specific Models); Restoring Location Lists (Specific Models)

Creating a new location:
Locations are identified by a unique location name. Each location name can only be allo-
cated once.
1
New location  .
2
Select
Location name  .
3
Enter values 
OK Save input  .
4
Execute steps
2
and
3
for the other criteria accordingly (only testo 330-2, -3 /
testo 330-2LL).
5
OK Go to measurement or OK TO memory/location  .
Ordering a list (testo 330-2, -3):
1
Locations list  .
2
Select the order criterion: , (only testo 330-2, -3 / testo 330-2LL) or
(only testo 330-2, -3 / testo 330-2LL).
Restoring a list (testo 330-2, -3):
1
Order the list in the sequence in which the locations were created:
Restore list  .
Activating a location:
Select the location  .
-
The location is activated and the
Measurements menu is opened.
Printing/displaying protocols:
If automatic furnace data are stored with a measurement protocol the following symbol
is displayed next to the protocol name: . The data are printed with the protocol
printout.
1
Select the location  .
Options:
To print all data of the chosen location:
Print all  .
To delete all data of the chosen location:
Delete all  .
2
To print a single data: Select the protocol  .
-oor-
2
To display saved readings of a measurement: Select the protocol  .
Options:
To print the protocol: .
To delete the protocol: .
Del
Print
Value
Print
OK
OK
Protoc.
OK
OK
Addr’
NameLocat
OK
OK
OK
change
OK
E. Operation
E.5 Memory/Location
24