TESTO 330-1 - Measurement Functions: Oil Flow Rate and Leak Detection; Oil Flow Rate Measurement; Leak Detection

G.2.10 Oil flow rate
The Oil flow rate function is only available if the activated fuel is an oil.
Calling up the function:

Measurements Oil flow rate  .
Measuring:
1
Enter the flow rate:
Flow rate Enter the value  .
2
Enter the oil pressure:
Oil pressure Enter the value  .
- The calculated oil burner output is displayed.
3
Copy the values to the
Flue gas menu: OK Copy readings  .
- The
Measurements menu is opened.
G.2.11 Leak detection
Gas is detected during leak detection; the gases are not measured.
A gas leak probe (0632 3330) must be connected.
Please refer to the documentation enclosed with the gas leak probe.
Calling up the function:

Measurements Leak detection  .
Measuring:
Carry out the setting for the gas to be detected according to the instructions found in
the documentation for the gas leak probe.
- The gas concentration is shown in a graph (trend display).
- An alarm message is given if the alarm threshold is exceeded.
Set alarm threshold: see
Alarm limits , p. 29.
OKOK
OK
OKChange
OKChange
OKOK
G. Measuring
G.2 Measurements
42