TESTO 330-1 - Measurement Sequences: BlmSchV and qA; qA Mean Value Measurement Sequence; BlmSchV Measurement Sequence

Calling up the function:

Measurements BImSchV  .
- Possibly: Gas zeroing (30 s).
If nno ffuel hhas yyet bbeen sselected:
Select the fuel  .
Activating/deactivating the CO measurement and Hot spot search:
1
Select
CO measurement ON or CO measurement OFF.
2
Position the flue gas probe in the hot spot (area of the highest flue gas temperature).
The display showing the current and maximum measured flue gas temperature (FT)
helps when positioning the probe.
Optional:
To reset the temperature value
max FT: .
qA mean value measurement sequence:
3
Start the measurement sequence: .
- The
qA menu is opened.
4
Start qA value measuring: .
- The three qA values are measured one after the other (25s respectively).
- The mean value of the three qA measurements is shown.
5
Copy the readings to the BimSchV menu: .
- The
BImSchV menu is opened.
Options:
To print readings: .
To save readings: .
Start flue gas measurement (BImSchV measurement sequence): continue with the
BImSchV sequence, Step
4
, on this page.
BImSchV measurement sequence:
3
Start the measurement sequence: .
- The
BImSchV menu is opened.
4
Start flue gas measurement: .
- The readings are displayed.
5
Stop flue gas measurement: .
- The
Draught menu is opened.
Stop
Start
BImS.
Save
Print
OK
Start
qA
Reset
OK
OKOK
G. Measuring
G.2 Measurements
37