TESTO 330-1 - Instrument Operation; Mains Unit and Rechargeable Battery; Probes and Sensors; Regular Care Procedures

E.4 Basic operating steps ..................................................................20
E.4.1 Switching the measuring instrument on ....................................20
E.4.2 Calling up a function ................................................................21
E.4.3 Entering values ........................................................................21
E.4.4 Printing data ............................................................................22
E.4.5 Saving data ..............................................................................22
E.4.6 Confirming an error message ....................................................22
E.4.7 Scanning locations with the barcode pen..................................23
E.4.8 Switching the measuring instrument off ....................................23
E.5 Memory / Location ......................................................................23
E.6 Instrument diagnosis ....................................................................25
F. Configuration........................................................................................27
F.1 Instrument settings ......................................................................27
F.1.1 Display edit ..............................................................................27
F.1.2 Printer ......................................................................................28
F.1.3 Alarm limits ..............................................................................29
F.1.4 Start Keys edit ..........................................................................29
F.1.5 Date / Time ..............................................................................30
F.1.6 Language..................................................................................30
F.2 Sensor settings ............................................................................30
F.3 Fuels ............................................................................................32
G. Measuring ............................................................................................33
G.1 Preparing measurements..............................................................33
G.1.1 Zeroing phases ........................................................................33
G.1.2 Using the modular flue gas probe..............................................34
G.1.3 Configuring the reading display ................................................34
G.2 Measurements..............................................................................35
G.2.1 Flue gas ....................................................................................35
G.2.2 Draught ....................................................................................36
G.2.3 BImSchV (testo 330-3 / testo 330-2LL) ....................................36
G.2.4 CO undiluted ............................................................................38
G.2.5 Smoke No. / HCT ....................................................................39
G.2.6 Differential pressure ..................................................................39
G.2.7 Differential temperature ............................................................40
G.2.8 O2 air........................................................................................41
G.2.9 Gas flow rate ............................................................................41
G.2.10 Oil flow rate ..............................................................................42
G.2.11 Leak detection ..........................................................................42
G.2.12 Ambient CO..............................................................................43
G.2.13 Ambient CO2............................................................................44
G.2.14 Burner control ..........................................................................45
Contents
5