www.ti.com
Hardware
These tabs allow you to see exactly what is happening in your application, and find power black holes. An
example application with the EnergyTrace++ windows is shown in Figure 9.
Figure 9. Debug Session With EnergyTrace++ Windows
After the EnergyTrace window is active, it can be controlled with the buttons in Table 2.
Table 2. EnergyTrace™ Technology Control Bar Icons
Enable or disable EnergyTrace Technology. When disabled, icon turns gray.
Set capture period: 5 sec, 10 sec, 30 sec, 1 min, or 5 min. Data collection stops after time has elapsed. However,
the program continues to execute until the Pause button in the debug control window is clicked.
Save profile to project directory. When saving an EnergyTrace++ profile, the default filename will start with
"MSP430_D" followed by a timestamp. When saving an EnergyTrace profile, the default filename will start with
"MSP430" followed by a timestamp.
Load previously saved profile for comparison.
Restore graphs or open Preferences window.
Switch between EnergyTrace++ mode and EnergyTrace mode
An example application using the MSP-EXP430FR5969 with EnergyTrace++ Technology is provided in
the application note: MSP430 Advanced Power Optimizations: ULP Advisor SW and EnergyTrace
Technology (SLAA603). For more details on EnergyTrace, refer to the Code Composer Studio v6.0 for
MSP430 User's Guide (SLAU157).
13
SLAU535B–February 2014–Revised July 2015 MSP430FR5969 LaunchPad™ Development Kit (MSP
‑
EXP430FR5969)
Submit Documentation Feedback
Copyright © 2014–2015, Texas Instruments Incorporated
To Next Page
Loading...
Need help?
General
