Premier 48, 88, 168 & 640 Installation Manual Specifications
INS176 101
Output Expanders
Electrical
Operating Voltage 9 - 13.7VDC
Current Consumption
Quiescent
Alarm (Nothing Connected)
65mA
65mA
Network
4-wire standard 7/0.2 alarm
cable up to 250m Star,
Daisy Chain or any
combination of the two
Bank 1 Outputs
Outputs 1 to 8
Bank 2 Outputs
Outputs 1 to 8
100mA switched to 0V
100mA switched to 0V
Environmental
Operating Temperature
-10°C (+14°F) to
+55°C (+131°F)
Storage Temperature
-20°C (-4°F) to
+60°C (+140°F)
Maximum Humidity 95% non-condensing
EMC Environment
Residential
Commercial
Light Industrial
Industrial
Physical
Dimensions (W x H x D)
170mm x 140mm x 35mm
Packed Weight 200g Approx.
Standards
Conforms to European Union (EU) Low Voltage Directive
(LVD) 73/23/EEC and Electro-Magnetic Compatibility (EMC)
Directive 89/336/EEC.
The CE mark indicates that this product complies with the
European requirements for safety, health, environmental and
customer protection.
This equipment is designed to enable an intruder alarm
system in which it is installed to comply with the requirements
of security grades 1, 2 or 3 of EN 50131-1 and EN 50131-6
and is suitable for installation in any indoor environment.
Warranty
All Texecom products are designed for reliable, trouble free
operation. Quality is carefully monitored by extensive
computerised testing. As a result the control panel is covered
by a two-year warranty against defects in materials or
workmanship.
As the control panel is not a complete alarm system but only
a part thereof, Texecom cannot accept responsibility or
liability for any damages whatsoever based on a claim that
the control panel failed to function correctly.
Due to our policy of continuous improvements Texecom
reserve the right to change specification without prior notice.
Premier Keypads and Expanders are protected by UK &
International Registered Design. Registered Design Numbers:
2089016 and 3004996.
Premier is a trademark of Texecom.
EN50131 Markings
All equipment is marked with the following information:
1) Name of manufacturer or supplier
This can be found on the PCB as part of the silk screen.
2) Description of the equipment
This can be found on the Barcode Label as either a full
description or as a code number.
Barcode Acronyms
FEC Premier 48 1.5Adc
FEN Premier 48 2Adc
NEE Premier 88
SEN Premier 168
PSF Premier 640
3) Standard to which component claims compliance
This can be found on a small white label along with the
security grade and environmental class.
4) Security Grade
This can be found on a small white label along with the
standard compliance and environmental class.
5) Environmental Class
This can be found on a small white label along with the
standard compliance and security grade
To Next Page
Loading...
