Programming the Control Panel Premier 48, 88, 168 & 640 Installation Manual
92 INS176
Do Bell Test
Yes
+$&+""/1&)0
,"))"01
HHHHHHHH
Press YES to test ALL
channels or use keys 0 - 8
to select individual channels
e.g. 3 = Channel 3
20%1,1"01
&$&FHHHHHHHH
3
def
HHHHHHHH
Press YES again to clear ALL
channels or use keys 0 - 8
to clear individual channels
e.g. 3 = Channel 3
Use the SCROLL key to
select the required test
Yes
2
abc
1,")" 1BX
+$&+""/1&)0
+$&+""/1&)0
&"43"+1,$
Press OMIT to invoke the
Engineers Hold Off mode
of a Texecom Bellbox
Omit
This option allows Allows the Bell, Speaker and various
control panel outputs to be tested.
The following outputs can be individually tested:
Test Bell The Bell output
Test Strobe The Strobe output
Test Speaker The Speaker output
Test Digi The Hardwired digicom outputs
Test Panel The panel outputs
Test RedCARE The plug on RedCARE outputs
Test Com???? The plug on digi outputs
LCD Display The LCD keypad display
User Outputs Any outputs that have the ‘User Test’
attribute (see page 66 for details).
Pressing OMIT at the Bell or Strobe Test will cause the
Strobe output to pulse 3 times, invoking Engineers
Hold Off mode if a Texecom bell box is connected.
Do Walk Test
Yes
+$&+""/1&)0
,4)(1"01G
Yes
2
abc
H
Yes
Press YES to walk test all
areas or use keys 1 - 8
to select/deselect areas
Menu
???
Chime
Press CHIME to select:
Chime Once then lockout zone
No Chime at all
Chime on every activation
or
,+"01%1+""!
1"01&+$/"B
,+"889F88?
/,+1,,/
Press AREA. to toggle the
display between the zones
that have been tested and
the zones that still need testing
rea
To view zones that have not
activated recently, e
i.e. 007 will show zones that have
not activated in the last 7 days
nter the
number of days required
,2+$"
1,")" 1BX
+$&+""/1&)0
+$&+""/1&)0
&"43"+1,$
Any of the zones on the system can be walk tested to ensure
that they operate correctly. A walk test can only be performed
when the system or area is disarmed.
Once a zone has been activated it will not generate a
chime tone again. If however the
key is pressed, a
zone will chime every time it is activated.
The Walk test menu also includes a last activation log that
can be recalled when doing a walk test. This log shows zones
that have NOT been activated over a period of days.
Pressing the
key will firstly show the zones that still need
testing, pressing the
key a second time will display the
zones that have not been activated that day, to view zones
that have not been activated for 3 days, type in 003 the
maximum number of days that can be recalled is 255,
pressing the
key a third time will revert back to the
standard walk test display.
To Next Page
Loading...
