Texecom PREMIER 88 - Plug-On Communicators

Premier 48, 88, 168 & 640 Installation Manual Installation
INS176 23
Plug-on Communicators
The Com300 is a multi format 8-channel digital
communicator/300-baud modem for use with a standard
analogue telephone line.
The Com2400 is a multi format 8-channel digital
communicator/2400-baud modem for use with a standard
analogue telephone line in addition, this modem can also send
Short Message Service (SMS) text messages to a mobile
phone.
The ComISDN is a multi format 8-channel digital
communicator/modem for use with an ISDN telephone line.
These Communicators can be used to report system events to
an Alarm Receiving Centre using Fast Format, Contact ID or
SIA Level II or to upload/download control panel information
using the Wintex UDL software and a PC.
Plugging on the Communicator
Ensure that the board is the correct way up (see below).
Locate the plug into the communicator socket on the control
panel and line up the mounting holes with the pillars in the
base. Once all the holes line up, press down gently until the
pillars snap into the holes.
Box
Ta m p
Standard Telephone Line Connections
A standard telephone line must be connected to the Com300
or Com2400 communicator as shown below:
R1
R
T
T1
To other telephone
extension sockets
Com300
Com2400
or
Master
Socket
T = 5 or A - White/Blue ring
R = 2 or B - Blue/White ring
3
2
1
6
5
4
Telephone cable
Type 1/0.5mm CW1308
This terminal must be connected to
the incoming AC Mains earth supply
ISDN Telephone Line Connections
An ISDN telephone line must be connected to the ComISDN
communicator as shown below:
ComISDN
ISDN
Ter mi nal
RJ45
Lead

For details on testing the communicators, see page 67.