Programming the Control Panel Premier 48, 88 & 168 Installation Manual
32 INS176
5. Programming the Control Panel
Introduction
All engineers should read this section carefully so as to
familiarise themselves with the programming of the control
panel.
To access the Programming menu, enter the factory default
Engineer code
.
If a mistake is made whilst entering the Engineer code, simply
re-enter the correct code.
WARNING
When an Engineers code is entered to gain
access to the Programming menu, by default
ALL zones and tampers are disabled.
On all panels prior to Version 3.0 Premier 48
and Version 6.0 Premier 88/168,
the Strobe output also pulse 3 times,
invoking Engineers Hold Off mode if a
Texecom bell box is connected.
A menu option can then be selected by pressing one of the
keys shown or by using the
key to search. Once
selected, press YES to access that option.
To leave the selected menu option and return to the main
programming menu, press
.
To exit from the Main Programming menu but still remain
‘Logged’ onto the system (zones and tampers still disabled),
press
and the display will show ‘Alarm Engineer
Working On Site’.
To log the Engineer off the system, press
followed by
YES and the system will revert to its normal condition.
The table below shows the menu options available:
Key Menu Option Page
Zone Setup 35
Area Programming 39
Global Options 47
Keypad Setup 56
Expander Setup 58
System Outputs 60
UDL/Digi Options 67
Setup Users 84
Engineer Utils 89
Alter Part Arms 98
The Arming Menu -
The User Menu -
Log Off Engineer 34
Exit programming mode 34
Enter Engineers Code
/"*&"/@9>@
189+:888
1,")" 1BX
"12-0"/0
8
tuv
1,")" 1BX
To Next Page
Loading...
