Premier 48, 88 & 168 Installation Manual Factory Defaults
INS176 31
Menu Option Default
7. UDL/Digi Options Continued
UDL Options Call Back Number 1 Not Defined
Call Back Number 2 Not Defined
Call Back Number 3 Not Defined
UDL Password Not Defined
DL Attended Unattended
Auto Call-Back Manual
Call Defeat Off On
DL Arm Limited At Anytime
Any Area Armed Fully Armed
DL Keypad not OK OK
Rings Required 005
UDL Dial Attempts 003
Area Accounts All Areas Not Defined
Setup Modules
Setup Radio-Pad ARC 1 Pri. No. Not Defined
ARC 1 Sec. No. Not Defined
ARC 1 Prefix Not Defined
ARC 2 Pri. No. Not Defined
ARC 2 Sec. No. Not Defined
ARC 2 Prefix Not Defined
ARC 3 Pri. No. Not Defined
ARC 3 Sec. No. Not Defined
ARC 3 Prefix Not Defined
Radio Pad Attempt 03
Setup AV Module? AV No.1> Not Defined
AV No. 2> Not Defined
AV No. 2> Not Defined
AV Dial Attempts 03
AV Re-Dial Delay 271 Minutes
Setup IP Data? ComIP Address Not Defined
ComIP Port Not Defined
ComIP Gateway Not Defined
ComIP Mask 03
Polling Address 271 Minutes
ComIP Name 271 Minutes
SMS Centre Pri. 07860980480
SMS Centre Sec. Not Defined
Modem Setup Stg. Not Defined
Modem Speed 2400
Com Port Setup Onboard Digi Com300
Com 1 No Module Fitted
Com 2 No Module Fitted
Expansion Port No Module Fitted
8. User Codes
Setup Users User 00 (Engineer) 1234
User 01 (Master) 5678 ****
All other Users Not Defined ****
* This options can alter the Programming as defined
below.
** These options are enabled/disabled when Config.
Option 33 is programmed as ‘Grade 2’.
*** These outputs are the same as the Com Channels
when Config. Option 33 is programmed as ‘Grade 2’.
**** All users except the engineer are defaulted to lock out
during entry.
To quickly change the programming for the ‘Digi
Outputs’ between Grade 2 and Grade 3 without having
to manually program each output, go to ‘System
Config.’ Which is in the ‘System Options’ menu and
select the required Grade (option 33), then go to
‘Default NVM’ which is in the ‘Engineer Utils’ menu,
select ‘Digi Outputs’ and then press ‘YES’ to default
them.
This will only default the Digi Outputs on the control
panel, no other programming will change.
To Next Page
Loading...
