YYYFYY
Press NO to
select/deselect
the option
There are 6 options that control how the plug-on
communicator works.
Select options by pressing keys 1 to 8 (a letter on the display
means the option is selected, a Dot on the display means the
option is not selected).
E - Digi is Enabled
The plug-on communicator will report all system events to the
Alarm Receiving Centre.
P - Pulse Dialling
The plug-on communicator will always dial telephone
numbers using pulse dialling.
3 - Pulse After 3
The plug-on communicator will always dial telephone
numbers using tone dialling. However, if the Communicator
fails to dial the number three times in a row, it will revert to
pulse dialling for the remaining attempts.
B - Blind Dialling
The plug-on communicator will not look for a dial tone before
dialling a telephone number.
U - Use MSN/Pre-Dial
The ComISDN will only answer a call when the programmed
MSN/Pre-Dial telephone number is dialled.
A - Dial All Numbers
If the communicator is acknowledged by the first ARC, it will
continue to dial any other programmed ARC. This is normally
used when a second or third ARC is programmed with SMS
Messaging.
Area Accounts
1,")" 1BX
Use keys 0 - 9 to enter
the account number
e.g. 1234 = Account 1234
/" ,2+1B
XX9:;<
Yes
Use keys 1 - 8 to select an
area or use the SCROLL key
to search e.g. 2 = Area B.
2
def
When using Fast Format, Contact ID or SIA, each area can
have its own account number to identify events.
Account Numbers A to H (I to P)
This is the account number that will be reported to the Alarm
Receiving Centre. Each account number can be up to 6
digits.
In order for the control panel to use the area account
numbers, the area account Config. option must be
enabled (see page 70 for details).
To Next Page
Loading...
